Flat

The Lay-in Flat panels have measure 600 x 600 mm on the outside, with a visual ceiling surface of 575 x 575 mm. They are made of 0.52 mm thermic galvanised steel and can be mounted in a T24 suspension structure. On the edges, they are lowered by 2 mm, which results in a smooth ceiling surface. These ceiling tiles are standard available in metallic silver and white. Other colors are available on demand. The ceiling panels can easily be pushed up to reach the above plenum and techniques.

The 15 mm or 24 mm Lay-in structure consists of a main profile of 3600 mm, to which 600 mm and 1200 mm cross profiles can be attached with a click-in system. The distance of the suspension points is recommended to be no more than 1200 mm. The Lay-in profiles can be attached with suspension wires (length: 3m, diameter: 4 mm). These wires can be cut and bent to the desired length. When using DROP tiles, T15 profiles are required; T24 profiles for FLAT tiles. The ceiling levelled using adjusting springs. 

 

The edges can be finished with either an L profile or a C profile.

When using the C profile, optionally tension springs (article number 45039) can be ordered, to make sure the tiles are pressed firmly against the edge finishing. Since the Lay-in DROP tiles are lowered by 8 mm. Ensure that the edge profiles are installed 8 mm lowered than the edge finishing. A levelling cube (article 46033) can be used, which has to be ordered separately. All edge profiles are supplied in 3 m length. 

And then there was...